Gamepad Calibration

Guides

DualSense Edge stick replacement

A DualSense Edge stick module comes out in about five minutes with no screwdriver and no soldering: pop off the faceplate, lift the release lever and pull the module out. That makes drift a quick fix, and it also opens the door to magnetic modules that do not drift at all.

Two removable analog stick modules for a premium controller lying side by side
Edge stick modules slide out as complete units. Original and third-party magnetic modules use the same slot.

Measure before you swap

Connect the Edge to a computer and run the Controller drift test. A module resting above 5% is drifting; a module that cannot reach the outer ring in the calibration tool has lost range. Measure both sticks: the swap fixes only the module you replace.

How do you swap a DualSense Edge stick module?

  1. Turn the controller off and disconnect the cable.
  2. Press the release button on the back to unclip the front faceplate, then lift the faceplate off.
  3. Lift the small release lever next to the stick module and pull the module straight out by its sides.
  4. Push the new module in until it seats fully and the lever clicks down.
  5. Refit the faceplate and turn the controller on.

No tools and no soldering are needed. The modules are keyed, so they only fit one way.

Premium controller with its faceplate removed and one stick module lifted out of its slot
Faceplate off, lever up, module out. The slot has a connector at its base and takes any compatible module.

Original, Hall effect or TMR: which module?

  • Original Sony module. Same potentiometer design as before, so it will drift again eventually. The safe choice for warranty and a guaranteed feel.
  • Hall effect modules from third-party makers measure the stick with a magnet and a sensor. Nothing wears, so they do not drift. Early ones had a slightly different centre feel; current ones are close to the original.
  • TMR modules are also magnetic but use a more sensitive sensor, giving finer resolution and lower power draw. They are the premium choice today.

Third-party modules plug into the same slot. Buy from a maker that lists Edge compatibility explicitly and publishes firmware notes.

Close-up of the small circuit board on the underside of a magnetic stick module
A magnetic module carries its own small sensor board. That board, not a carbon track, reads the stick.

Calibrate after the swap

A new module, especially a magnetic one, has its own centre and range. Check it in the calibration tool on this site: the stick should rest at zero and reach the outer ring in every direction. On the PS5, open Settings → Accessories → DualSense Edge and adjust the stick deadzone in your profile if needed. If the module ships with its own calibration procedure or firmware, follow it; some magnetic modules need a one-time calibration before they report full range.

Does a module swap void the warranty?

Swapping Edge modules is a user operation Sony designed for, so installing an original module does not affect the warranty. Third-party modules are a grey area: keep the original module so you can put it back before a warranty claim.

Frequently asked questions

Do I need to recalibrate after installing an original module?

Usually not, but check it in the calibration tool. If it rests off-centre or stops short of the rim, adjust the deadzone in the Edge profile.

Can Edge modules go into a regular DualSense?

No. The regular DualSense has soldered stick modules; only the Edge has the removable slot.

Do magnetic modules change the feel?

Slightly. The tension and centre feel depend on the module's spring, not the sensor. Many makers offer different spring tensions.

Check the new moduleZero at rest, full ring at the edge. Confirm it before you close the faceplate for good.
Open the calibration tool